How to Install a Brushed-Aluminum Backsplash

by:AchiKing     2020-06-26
Brushed-The aluminum back panel offers the stylish look of the tin back panel in a soft metal finish.The classic design of embossed metal bricks not only brings a stylish modern atmosphere to your kitchen, but also makes it feel like a professional kitchen.Brushed-The aluminum tailgate consists of tiles or panels that are glued to your wall with a polyurethane building adhesive.The labor intensity of this process is much smaller compared to installing tiles, and the tailgate is easy to clean.Wash off the surface of the wall that will be installed to brush the aluminum tailgate.Use a solution of skim soap and warm water to ensure the surface is as clean as possible.Measure the area you are covering with the tailgate.Cut brush-Aluminum back plate same size as heavy dutyduty shears.If you are going to use a brushed aluminum tile to make the tailgate, spread them on a flat surface according to the size you just measured.Cut brushed aluminum tiles as needed to fit the edges and corner areas of the wall.The installation process of the pull aluminum back panel and the pull aluminum tile is the same.Place the back panel against the wall in the desired position.Cut as needed to fit the size.Place the aluminum tailgate or brush aluminum tile in a flat working space with the back or dull side facing you.The back of the panel or tile may not be the same color as the silver surface on the top of the tailgate, or may not be that shiny, depending on the material.Run a polyurethane building adhesive 1 inch from the edge throughout the perimeter of the tailgate or aluminum tile.The diameter of the beads should be 1/4.Diagonally wear a circle of building adhesive on the back of the tailgate, from the top left to the bottom right, from the bottom left to the top right, making an X-shape.Run another building adhesive on the middle line of the tailgate or tile so that it passes through X-The shape you make with adhesive.Take care to pick up the tailgate or aluminum tile, avoid touching your finger with adhesive and lift it to the wall.From the right, tilt the tailgate or tile to the wall.When you push the tailgate or tile into the wall with another hand, please keep the left side up.As you walk, press along the surface of the tailgate or tile and slowly place the left edge of the tailgate or tile against the wall.Press the tailgate or tile to the wall, start from the center and move outward to eliminate any air bag and apply the adhesive evenly to the wall.Continue to add panels or tiles the same way until you cover the entire tailgate area on the wall.Cut edge J-If the aluminum plate or tile does not extend all the way to the corner of the wall, trim by size.Sliding edge J-Trim to the outer edge of the panel or tile.If there is no extra adhesive for J-The ornament to be pressed in, apply a layer of adhesive along the back of the ornament, slide it to the outer edge of the panel or tile, and press it to the wall.During installation using a clean, damp sponge, immediately remove any excess adhesive that may squeeze out the edge of the side.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...